BTW, what is the SD card for?
is there a way I can build an external midi interface (i already have an arduino midi shield) or even connect its wires straight to some pins on the board?
which board has the midi input? after I received it I saw that the midi in was optional...
can you tell me if this programmer would work for uzebox?
there's a shop they sell it here in Brazil, so it would be easier and faster.
- When I try to connect to the board I always get this message: "entering programming mode... FAILED" it happens at the connect/main tab and at the program tab when I click on verify or program. What's wrong?
- How and where do I preview the animations?
- Is there a way to preview the programming in avr studio? to emulator I can only initialize when I drag and drop a HEX file on it. Isn´t there a interface for the emulator where I can modify the code?
- What type of file should I upload to the board? at the program tab there are flash, eeprom and elf. which one should I use? Is this the right place to upload the programming to the board?
I assume you followed instructions at http://www.ladyada.net/make/usbtinyisp/ ... ompat.html? Can you post print screens of all the tabs in the AVRISP box? i.e: Main, Program, Fuses, etc.
What animations are you referring to?
Btw, If not already done, you need to download WinAVR. It's the pack that will allow you to use C to program stuff.
Users browsing this forum: No registered users and 1 guest