Hi Uze,
do you have a schematic for the connection between ATMEGA and ESP8266 module?
I assume:
- UART (TXD and RXD)
- GND
- 3,3V DC ???
Best Regards
Hartmut
New PCB rev on the horizon
Re: New PCB rev on the horizon
Life's too short to remove usb safely
Web: www.hwhardsoft.de
http://www.facebook.com/hwhardsoft
YouTube: http://www.youtube.com/user/hwhardsoft
Web: www.hwhardsoft.de
http://www.facebook.com/hwhardsoft
YouTube: http://www.youtube.com/user/hwhardsoft
Re: New PCB rev on the horizon
Hi Harty,
I'll post the schematic tonight when back from work.
Cheers!
I'll post the schematic tonight when back from work.
Cheers!
Re: New PCB rev on the horizon
Hi Harty, here's the schematic. It uses 2 more line to control the ESP12: one to reset the module and the other to initiate serial firmware update. Note that firmware update has not been tested yet so I don't even know if it is going to work.
- Attachments
-
- Uzebox Game Console F5.pdf
- (30.72 KiB) Downloaded 1082 times
Re: New PCB rev on the horizon
Thx for your reply. I will create an application note for the EUzebox. The actual pcb have a breadboard area. Its very easy to solder and wire an ESP module there. I will try to use this module:uze6666 wrote:Hi Harty, here's the schematic. It uses 2 more line to control the ESP12: one to reset the module and the other to initiate serial firmware update. Note that firmware update has not been tested yet so I don't even know if it is going to work.
http://www.electrodragon.com/w/ESP8266
Life's too short to remove usb safely
Web: www.hwhardsoft.de
http://www.facebook.com/hwhardsoft
YouTube: http://www.youtube.com/user/hwhardsoft
Web: www.hwhardsoft.de
http://www.facebook.com/hwhardsoft
YouTube: http://www.youtube.com/user/hwhardsoft