Page 6 of 6
Re: New PCB rev on the horizon
Posted: Mon Oct 26, 2015 4:56 pm
by Harty123
Hi Uze,
do you have a schematic for the connection between ATMEGA and ESP8266 module?
I assume:
- UART (TXD and RXD)
- GND
- 3,3V DC ???
Best Regards
Hartmut
Re: New PCB rev on the horizon
Posted: Mon Oct 26, 2015 5:31 pm
by uze6666
Hi Harty,
I'll post the schematic tonight when back from work.
Cheers!
Re: New PCB rev on the horizon
Posted: Mon Oct 26, 2015 11:57 pm
by uze6666
Hi Harty, here's the schematic. It uses 2 more line to control the ESP12: one to reset the module and the other to initiate serial firmware update. Note that firmware update has not been tested yet so I don't even know if it is going to work.
Re: New PCB rev on the horizon
Posted: Sun Nov 01, 2015 7:36 pm
by Harty123
uze6666 wrote:Hi Harty, here's the schematic. It uses 2 more line to control the ESP12: one to reset the module and the other to initiate serial firmware update. Note that firmware update has not been tested yet so I don't even know if it is going to work.
Thx for your reply. I will create an application note for the EUzebox. The actual pcb have a breadboard area. Its very easy to solder and wire an ESP module there. I will try to use this module:
http://www.electrodragon.com/w/ESP8266